The Brighter Choice
 |
CE marked |
 |
Class I rated - Basic insulation and all exposed conductive parts connected to an earth terminal. |
 |
Class II rated - Basic and supplementary insulation in accordance with BS EN60598. No provision for an earth connection. |
 |
The control gear in this fitting carries the ENEC mark |
 |
Protected against 5 joules impact. Equivalent to impact of 1.7kg mass dropped from 300mm above impacted surface. |
 |
Protected against 10 joules impact. Equivalent to impact of 5kg mass dropped from 200mm above impacted surface. |
 |
Protected against 20 joules impact. Equivalent to impact of 5kg mass dropped from 400mm above impacted surface. |
 |
Protection against solids larger than 12.5mm. No protection against liquids. |
 |
Protection against solids larger than 1mm.No protection against liquids. |
 |
Protection against solids larger than 1mm. Protection against splashed liquids. |
 |
Limited protection against dust ingress (no harmful deposit). Protection against splashed liquids. |
 |
Limited protection against dust ingress (no harmful deposit). Protected against low pressure water jets from any direction (Limited ingress permitted). |
 |
Totally protected against dust ingress. Protected against low pressure water jets from any direction (Limited ingress permitted). |
 |
Totally protected against dust ingress. Protected against high pressure water jets from any direction (Limited ingress permitted). |
 |
Totally protected against dust ingress. Protected against short periods of immersion in water. |
 |
Totally protected against dust ingress. Protected against long, durable periods of immersion in water. |
 |
This fitting has been tested and found suitable for use in solid timber and I-beam ceilings fire rated to 30, 60 and 90 minutes to BS476. |
 |
This fitting is supplied with a 5-year unlimited hours warranty. |
 |
This fitting is supplied with a 7-year unlimited hours warranty. |
 |
This fitting is certified for use in wood, paper and textile processing plants. This symbol confirms that the outer surfaces of the luminaire on which highly flammable substances such as dust or fibres may gather do not exceed the temperature limits specified in EN 60598-2-24. |
 |
The L value (70 in this case) is the expected average lumen output of the fitting, expressed as a % of its initial output, at the end of its rated life. The lower value (50,000 in this case) is the rated life of the product in hours |
 |
The L value (80 in this case) is the expected average lumen output of the fitting, expressed as a % of its initial output, at the end of its rated life. The lower value (100,000 in this case) is the rated life of the product in hours |
 |
When new, the colour of the light emitted by all the fittings in any one batch will fall within 3 standard deviations of each other. |
 |
When new, the colour of the light emitted by all the fittings in any one batch will fall within 5 standard deviations of each other. |
 |
The thermoplastic diffuser material in this fitting has been tested and found to have the characteristics required for TP(a) rating. |
 |
The thermoplastic diffuser material in this fitting has been tested and found to have the characteristics required for TP(b) rating. |
 |
This fitting can be controlled with a 1-10V (analogue) control signal |
 |
This fitting is dimmable with suitable mains (phase cutting) dimmers. |
 |
Emergency versions of this product are available. They are fitted with lithium iron phosphate (LiFePO4) batteries. |
 |
HubSense smart wireless control options are available. |
 |
Environmental Product Declaration. An EPD, evaluated in line with ISO 14025:2006 |
 |
ICEL is the Industry Committee for Emergency Lighting, part of the Lighting Industry Association (LIA). ICEL Endorsed products have been independently tested to the relevant standards and the test reports assessed and checked by ICEL. |
